Zebra 10/100 Podręcznik Użytkownika Pobierz pdf (Strona 85)

Hardware Troubleshooting

Troubleshooting the 10/100 PS

07/18/2008 BradyConnect 10/100 Internal Print Server User Guide Y885775

Telnet

Open a telnet session to send a ZPL command from a DOS prompt. This procedure can be

used when running Vx.15.x or later firmware. In this example, a ZPL II command is used to

cause a label to print.

To open a telnet session on your PC, complete these steps:

1. Open a DOS window.

To open a DOS window, click on

Start > Run.

2. In the Open text box, type: cmd

3. From the DOS prompt, type:

telnet xxx.xxx.xxx.xxx 9100

where xxx.xxx.xxx.xxx is the IP address of the print server.

This will connect your PC to the 10/100 Internal PS through the parallel port of the printer.

4. Enter ~WC.

This ZPL command will print a configuration label on your printer.

5. Click the X in the upper right-hand corner of the window to exit.

If the configuration label prints, the issue is not a communication problem between the printer,

the print server, or the PC.

Note • You do not need to open a telnet session if you pinged the printer using the previous

procedure. The purpose of these two procedures is to identify whether your PC can

communicate with your printer.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 105 106

Brak uwag

Zebra 10/100 Podręcznik Użytkownika Strona 85