Zebra Eltron Card Printer Podręcznik Użytkownika Strona 70

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 69
5.2.8 Ribbon Sensor Removal
The four wires of the Ribbon Sensor connect to the Daughter Board. Refer to Figure 5-12, and
proceed as follows:
Step 1. Remove Rear Case, and disconnect the wires from the CPU Board, and if
installed, the Encoder Board (see Sections 5.2.1, 5.2.10, and 5.2.11).
Step 2. Remove the Rear Plate with attached circuit boards (see Section 5.2.11).
Step 3. Remove the single screw holding the Ribbon Sensor.
Step 4. Cut the Cable Ties holding the Ribbon Sensor wires.
Step 5. Unplug the Ribbon Sensor Connector from the Daughter Board.
Step 6. Remove the Ribbon Sensor while feeding the associated cable and connector
along the routing path.
5-14 980264-001 Rev.B
CHAPTER 5
Figure 5-12. Ribbon Sensor Removal.
Przeglądanie stron 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 111 112

Komentarze do niniejszej Instrukcji

Brak uwag