Zebra Z6Mplus Podręcznik Użytkownika Pobierz pdf (Strona 76)

Configuration

Setup Mode

13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06

Setup Mode

After you have installed the media and ribbon and the Power-On Self Test (POST) is complete,

the control panel displays

PRINTER READY. You may now set printer parameters for your

application using the control panel display and the buttons directly below it. If it becomes

necessary to restore the initial printer defaults, see FEED and PAUSE Self Test on page 132.

Enter Setup Mode

To enter Setup Mode, complete these steps:

1. Press SETUP/EXIT.

2. Press PLUS (+) or MINUS (–) to scroll through the parameters.

3. Press SELECT to select and deselect the parameters.

Important • Certain printing conditions may require that you adjust printing parameters,

such as print speed, darkness, or print mode. These conditions include (but are not

limited to):

• printing at high speeds

• peeling the media

• the use of extremely thin, small, synthetic, or coated labels

Because these and other factors affect print quality, run tests to determine the best

combination of printer settings and media for your application. A poor match may limit print

quality or print rate, or the printer may not function properly in the desired print mode.

Note • If the printer is operating on an IP network, you can change the printer’s parameters

in these additional ways:

• with ZebraLink™ WebView (ZebraNet

10/100 PrintServer or ZebraNet Wireless Print

Server required). For information, see the appropriate print server user guide.

• with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For

information, see the ZebraNet Wireless Print Server User Guide.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 165 166

Brak uwag

Zebra Z6Mplus Podręcznik Użytkownika Strona 76