Zebra EPL2 Instrukcja Użytkownika Strona 81

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 82
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 80
Deactivating the
EPL1 Fonts
1. 1. Set the reconfigure the printer for Page
(EPL2) Mode. Send a EPL2 command to the
printer.
2. Send the EPL2 U command to the printer.
The printer will print a Dump Mode status re
-
port. If it prints a U, then the print is still in Line
Mode and steps 1 and 2 need to be repeated.
3. Send the EPL2 o (Clear Special Mode Op
-
tions) command to the printer.
4. Send the EPL2 OEPL1 (Set Line Mode)
command to the printer. Send a Line Mode
EPL? command to the printer to print a Dump
Mode printout. Verify that the printer is in Line
Mode and that the status line immediately be
-
low the Option:” line has been cleared of the
following: oEw, x, y, z
Typically the last two lines will read:
Options:
04 07 10 << label sensor readings
Cycle the printer power and repeat steps3&4if
the printer is not in Line Mode or the fonts have
not been cleared.
980353-001 Rev.B C-3
Przeglądanie stron 80
1 2 ... 76 77 78 79 80 81 82

Komentarze do niniejszej Instrukcji

Brak uwag