Zebra TTPM3 Dokumentacja Pobierz pdf (Strona 8)

Introduction

Document Printing

P1003642-001 TTPM3 Installation and Programming Manual 01/06/2009

Document Printing

TTPM3 uses the direct thermal printing technique and can print the entire surface of the ticket

with text, bar codes, or graphics, or any combination hereof. Text block position and

orientation is software programmable as is the character size.

The data sent to the printer is converted to a ticket image which is stored in the unit until an

“All Clear” software command is sent, or the power is turned off/on.

Magnetic Encoding

Three magnetic tracks can be encoded: Either with standard low coercivity recording, or

optional “household-magnet proof” high coercivity recording.

The TTPM3 can be used for encoding on one, two, or three tracks simultaneously.

Read-after-write is automatically performed.

You can also enter an already encoded ticket into the TTPM3 and read the magnetic stripe and

output the data to the host computer.

See also Magnetic Encoding/Decoding Commands on page 38.

Document Handling

TTPM3 printer has two rear inputs for ticket stock. Both can take continuous ticket stock like

fanfold or roll ticket material. You can configure the printer so that one is used for continuous

stock and the other is used for handfed tickets.

There is an optional front load mechanism that makes it possible to load single tickets through

the ticket exit. This replaces the upper ticket entry at the rear of the printer. In addition to this,

the front load has a wastebasket function for redirecting used or invalid tickets to a

wastebasket, thus preventing useless tickets being presented to the customer.

You can select to partially eject the ticket so that the customer takes it from the frontload

mechanism, or fully eject the ticket so that it falls into a tray. You can also select that a ticket

should be redirected to a wastebasket as described above.

ISO track version ISO track 1 at 210 BPI

ISO track 2 at 75 BPI (Bits-Per-Inch)

ISO track 3 at 210 BPI

Center track version 7 mm wide center track at 75 or 210 BPI

Note • Encoding in ISO standard format, or in hexadecimal format (bit-by-bit), is software

selectable.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 111 112

Brak uwag

Zebra TTPM3 Dokumentacja Strona 8