Zebra RW SERIES Dokumentacja Pobierz pdf (Strona 20)

RMAN-RWS-001 rev. B • RW Series Repair Procedures • 2-20 •

Replacing the Platen Assembly

Remove the Old Platen Assembly

1. Remove and retain the two screws holding the Holder, Platen to the Media

Cover.

2. Carefully rotate the Holder, Platen towards the interior of the printer until it is

free from the media cover.

Avoid putting strain on the sensor cable which is adhered to the inside of the

Holder, Platen. Do not exert excessive force on the Holder, Platen when it is removed

from the Media Cover.

Remove the Platen Assembly from the Holder, Platen.

Install the New Platen Assembly

1. Install the new Platen Assembly into the Holder, Platen, noting the location of

the Gear at “1”.

2. Rotate the Holder, Platen back into the Media Cover until it snaps into place as

shown at “2”. Ensure that the new Platen Assembly spins freely.

3. Secure the Holder, Platen to the Media Cover with the (2) retained Screws.

Accessory Kits AK17393-002 & AK17393-028

RW 420 Platen/Gear

Installation Instruction

This kit includes the parts and documentation necessary to install the AK17393-002

Platen/Gear Kit or AK17393-028 Linerless Platen/Gear Kit in the RW 420 model

printer. Read these instructions thoroughly before attempting to install this kit.

 Caution•TheoperatormustwearaproperlygroundedESDstraptoperformthe

following repair procedure.

Reference Materials

UMAN-RWS RW Series Users’ Guide

Tools Required

#0 or #1 Phillips Head Screw Driver

Cautions

Unless otherwise specied:

• Always turn the printer off

• Remove the battery before installing any Replacement Kits.

• Remove media before installing this Replacement Kit.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 113 114

Brak uwag

Zebra RW SERIES Dokumentacja Strona 20